![[Upcoming Updates] Death Star pumpkin updates are in the works based on your feedback](https://img5.samsuka.com/storage/9/bs/vy/c6f9d9-019e826c-b205-72be-8d2b-48355847c0f0.jpg)
[Upcoming Updates] Death Star pumpkin updates are in the works based on your feedback
Added 2022-10-17 17:09:34 +0000 UTCSome changes to the files are in the works for the death star pumpkin so if you haven't started printing yet you might consider waiting.
Changes will include:
Thinner walls
Flatter bottom
Lid with separated stem
Bottom removed for separated printing
Dome divided in half for support-less printing version
Sorry for not including these in the first release but I'm considering it a learning opportunity for future models like this!
Comments
Yeah I'd like to get it down to at least a 24 hour total print if possible. With as little supports needed to save time too. You might have to glue the two halves together but I think that would be it
Aaron Hughes
2022-10-17 17:22:06 +0000 UTCGood to know. I've printed from the beltline up, and was just starting to print the bottom half upside down and modded to reduce center support need. Looks great so far.
Ron St Germain
2022-10-17 17:21:58 +0000 UTCThank you I did a test print and the support messed up the bottom, then I did it upside and came out better but using a ton of support in the middle. Then I did it with no support and the inside comes out all stringy. But mine were all 30% size to test.
3DPrintingWizardry
2022-10-17 17:18:03 +0000 UTC
