ABS is running!
Added 2019-04-05 18:48:48 +0000 UTCMy first ever abs print. I setup a very generic profile specifically for this Atomic ABS and hit print. It's looking good so far but nothing too difficult.
Initial observations.
1. It's sticking to the pei. I did clean it with acetone first to give it a good chance to work.
2. Smell isn't bad. It's noticeable but not bad at all.
3. Layers look to be printing fine. Going to do the break in my hand test to see how good or bad adhesion is.
4. No warping! Yet 😅
5. I guessed well but will definitely see some dialing in needed here in the future.
![さとと [satoto]](https://samsuka.com/istorage/108048.jpg)
