It has begun!
Added 2019-04-22 16:44:37 +0000 UTCSlowly the build has begun.
I've built the frame and some of the printed parts are attached and ready for their necessary components. I'll do a live stream with the fancy components being installed once they all arrive which should be tomorrow besides a Slice thermistor which I'll add later to this project.
Big shout out to Chris Riley from Chris's Basement, different basement than my own, for helping me with the firmware end of the project. Without that dude I'd be on older Marlin and not setup correctly. Please give the man a follow on his YouTube since the guy truly is a beast at modding and teaching users how to make their printers do things better.
This printer is 100% happening thanks to the votes in the previous poll about what I should build next. I definitely took my time getting here but wanted it to be extra badass for all y'all crazy awesome humans.
Once I get it running and the firmware is running I'll post the firmware for everyone here first and then I'll try and figure out GitHub once again. 😅
On that note I'm going to finish terminating some wires and making sure all the motor cables are properly setup for the board. I think I need to flip the two center wires from a previous test but will check that asap.
Thank you all and hope you each had an enjoyable Easter. Now back in the lab I go!!!
