Einsy retro hates me π
Added 2019-04-29 03:53:54 +0000 UTCHours and hours of changes and questions to smart people and nobody had come up with an answer.
Basically whenever we get to retractions or lots of small moves the extruder decides to just give up.
I've run the firmware in Marlin 2.0 and 1.1.9 and changed all sorts of paraments. I've replaced hoteneds twice and increased and decreased motor currents. Everyone I know is stumped. Heck even the TMC report says everything is fine.
As a last ditch effort I'm going to make connectors to wire this into an MKS Gen L board and see what happens. Part of me thinks the einsy retro is being a butt.
Taking a break and getting caught up on CF Petg prints. Will report back my findings once I have a moment to try a different board.
