Mickey Mouse Clean
Added 2022-08-31 22:38:17 +0000 UTCRESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
FDM
LAYER HEIGHT 0.28
INFILL AT 20 PERCENT
STANDARD SUPPORTS
GYROID PATTERN
215 NOZZEL
60 BED TEMP
60 MM/S
SUPPORT NORMAL / OVERHANG 50
SUPPORT PATTERN LINES
He printed on the fist try with no issues but after a particularly difficult battle with some supports, resulting in mickey losing a finger and half of his tail, I decided to also include the tail separately in case anyone else runs into the same problem. After a little sanding and some careful placement you'd never know. Thankfully he stands fine without the tail so I wouldn't worry if you cant get it perfectly accurate to the floor. With it being so thin its a little temperamental but it did print fine 5/6 times with a brim enabled and the speed reduced to 40.
Any questions or issues please drop me a message, I'll be happy to help. Stay tuned for ornamental variants and a final model update including painting details and photos!
Thanks again for subscribing!
Harley
