PoisonApplePrints

Mickey Mouse Ornamental

Added 2022-08-31 22:38:30 +0000 UTC

RESIN

45 DEGREE ANGLE

DENSITY 75 PERCENT

FDM PATCHWORK VARIANT

LAYER HEIGHT 0.28

INFILL AT 20 PERCENT

STANDARD SUPPORTS

GYROID PATTERN

215 NOZZEL

60 BED TEMP

60 MM/S

SUPPORT NORMAL / OVERHANG 50

SUPPORT PATTERN LINES

This variant was a last minute decision to test how the print runs on FDM its the same file as the above version with a different paint scheme. I used my standard settings for the print but I'm going to up the layer height next month to improve the quality in some areas. Also to note the deco patterns do flag an error message on Cura (nothing I can do about this unfortunately) but don't worry he will print perfectly fine, I've tested it on a number of different models.

He printed on the fist try with no issues but after a particularly difficult battle with some supports, resulting in mickey losing a finger and half of his tail, I decided to also include the tail separately in case anyone else runs into the same problem. After a little sanding and some careful placement you'd never know. Thankfully he stands fine without the tail so I wouldn't worry if you cant get it perfectly accurate to the floor. With it being so thin its a little temperamental but it did print fine 5/6 times with a brim enabled and the speed reduced to 40.

Any questions or issues please drop me a message, I'll be happy to help! Stay tuned for a final model update including painting details and photos.

Thanks again for subscribing!

Harley