PoisonApplePrints

Winnie The Pooh (Clean Variant)

Added 2023-05-05 02:32:00 +0000 UTC

The first version of Pooh is now all ready to download below! The test print ran nice and smoothly, with a well placed drain hole to the underside of his belly. He should be fine printing on either resin or FDM since he has no small areas, but the bees wings unfortunately may not survive on FDM.

I've printed him at 12cm tall, which is a little shorter than Mickey to account for him being sat down, he's turned out a pretty nice size to go alongside the rest of the collection without looking too big or out of proportion.

RESIN

45 DEGREE ANGLE

DENSITY 75 PERCENT

RAFT SHAPE SKATE

FDM

LAYER HEIGHT 0.2

INFILL AT 20 PERCENT

TREE SUPPORTS

GYROID PATTERN

220 NOZZEL TEMP

60 BED TEMP

65 MM/S

SUPPORT NORMAL / TOUCHING BUILD PLATE

OVERHANG 45

SUPPORT PATTERN LINES

RAFT ENABLED

EDIT- I accidentally uploaded an earlier file version, which caused a blow out in the bottom of the honey pot, due to it being hollow. I've now attached the correct file, which is solid and prevents it from happening. Sorry to anyone who's had issues with this, I'm drowning in files and off my game because I'm ill but I'll do my best to be a bit more careful in future.

Any questions or issues just let me know. The Ornamental version will be out on the page in a few days, don't forget to check the WIP post for updates!

See you in the next post,

Harley