Winnie The Pooh (Ornamental Variant)
Added 2023-05-10 02:47:01 +0000 UTCThe decorated version of Pooh is now all ready to download below! The test print again ran nice and smoothly, with a well placed drain hole to the underside of his belly. He should be fine printing on either resin or FDM since he has no small areas, but the bees wings unfortunately may not survive on FDM.
I've printed him at 12cm tall, which is a little shorter than Mickey to account for him being sat down, he's turned out a pretty nice size to go alongside the rest of the collection without looking too big or out of proportion.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
RAFT SHAPE SKATE
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
SUPPORT NORMAL / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
RAFT ENABLED
Any questions or issues let me know! The photo post for my printed and painted models will be out in a day or so, followed by some lovely little surprises to end our Winnie The Pooh models!
See you in the next post,
Harley
