Flounder (Clean Variant)
Added 2023-05-19 20:50:17 +0000 UTCThe first version of flounder is now all ready to download below! The test print ran smoothly and I'm happy to report he balances fine on his fins. I printed him at 8cm tall and he's a little face heavy due to the shape of the model so if he ends up a bit like a weeble wobble, some light sanding to the underside corner of his tail should fix the issue. He also has no small or fine areas other than the finer spikes on his hair so he should print fine on both resin and FDM.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
RAFT SHAPE SKATE
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
SUPPORT NORMAL / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
RAFT ENABLED
Any questions or issues let me know. The Ornamental version will be out in a few days, so don't forget to check the WIP post for updates!
See you in the next post,
Harley
