Flounder (Ornamental Variant)
Added 2023-05-22 22:54:07 +0000 UTCDecorated flounder is now ready to download below! this time I printed him at 6cm tall on FDM and the test print ran great. I've had an awesome idea for a little home for him to live in and I needed a smaller version of him to work with that, but the attached stl is still 8cm tall like the original clean version. I'll be making Flounder's home in a few weeks on the page so stay tuned for that and I'll release some more info nearer the time.
Again, he's a little face heavy due to the shape of the model so if he ends up a bit like a weeble wobble, some light sanding to the underside corner of his tail should fix the issue. He also has no small or fine areas other than the finer spikes on his hair so he should print fine on both resin and FDM.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
RAFT SHAPE SKATE
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
SUPPORT NORMAL / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
RAFT ENABLED
Any questions or issues let me know. The photo post will be out in a day or so to get a look at my fully finished models!
See you in the next post,
Harley
