PoisonApplePrints

Mushu (Clean Variant)

Added 2023-01-26 03:41:24 +0000 UTC

2 successful test prints later and Mushu officially stands and is ready to be printed! I printed him solid to avoid suction issues and at 45 degrees to the right in order to support his chin better. Both STL's are available below, with and without the gong. I printed both versions to make sure they are balanced properly and am happy to report they both stand up perfectly, the gong however acts as a counter balance to the model and makes it a lot sturdier than the other one.

RESIN

45 DEGREE ANGLE

DENSITY 75 PERCENT

RAFT SHAPE SKATE

FDM

LAYER HEIGHT 0.2

INFILL AT 20 PERCENT

STANDARD SUPPORTS

GYROID PATTERN

220 NOZZEL TEMP

60 BED TEMP

65 MM/S

SUPPORT NORMAL / TOUCHING BUILD PLATE

OVERHANG 45

SUPPORT PATTERN LINES

Any questions or issues please drop me a message, I'll be happy to help. The ornamental variant will be out by Friday along with some updated renders, I'll keep the Mushu WIP post updated as I go.

Thanks for subscribing!

Harley