Ray (Clean Variant)
Added 2023-09-22 02:27:01 +0000 UTCSorry folks technical difficulties, but Ray is now all finished and ready to download below. I printed him at 8 cm tall which makes him a nice small size to fit in with the rest of the models. He is basically built of fine areas so I'm not sure how well this will hold up on FDM but you may have some success using a 0.2 nozel if you upscale him to a larger size.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
SUPPORT NORMAL / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
Any questions or issues just let me know. I'll be working on the patterned version throughout tomorrow so he'll be up on the page sometime in the evening.
See you in the next post,
Harley
Comments
Hi, yeah I printed him tilted backwards at a 45 degree angle with light supports and a few heavy supports dotted about as anchor points. Hope this helps!
PoisonApplePrints
2023-09-25 16:56:26 +0000 UTCHello, for the resin do you need supports I just got a new machine. get used to FDM. thank you very much
Aurélie Houbron
2023-09-25 14:48:31 +0000 UTC
