Ray (Ornamental Variant)
Added 2023-09-23 14:05:16 +0000 UTCOrnamental Ray is now all finished and ready to download below. I printed him solid at 8 cm tall which makes him a nice small size to fit in with the rest of the models. He is basically built of fine areas so I'm not sure how well this will hold up on FDM but you may have some success using a 0.2 nozel if you upscale him to a larger size.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
SUPPORT NORMAL / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
Any questions or issues just let me know. I'll have photos out of my printed model later, followed by the next addition to our cupcake jars!
See you in the next post,
Harley
Comments
Awesome, I look forward to it, good luck with the prints! 😊
PoisonApplePrints
2023-09-24 23:48:06 +0000 UTCThis is my next project for my FDM printer. First it’s time for Cinderella’s slipper. I’ll let you know how it has turned out 😊
Mike Keijzer
2023-09-23 14:18:32 +0000 UTC
