Eeyore (Clean Variant)
Added 2023-09-30 00:23:00 +0000 UTCEeyore is now ready to download below! I printed him at roughly 10 cm tall which makes him a nice fit in proportion with our Winnie the Pooh model. It was a fairly straightforward print with a drain hole placed on each foot for suction and drainage purposes. He also doesn't have any thin or fine areas so he should be fine printing on either Resin or FDM.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
SUPPORT NORMAL / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
Any questions or issues just let me know. The patterned version will be out throughout tomorrow, with the photos to follow on Sunday!
See you in the next post,
Harley
