Maleficent's Dragon (Ornamental Variant)
Added 2024-02-09 16:22:02 +0000 UTCThe final version of the dragon is now all ready to download below! again I've set the model at 17cm tall which makes her a couple of cm bigger than our Lotso model. She should print fine on resin or FDM but a drain hole is recommended for the end of her tail to prevent suction issues and organic supports are recommended for her spikes and mouth.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
ORGANIC SUPPORTS / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
Any questions or issues let me know! Later on today I'll have the pre-supported files out for the dragon alongside an exciting new announcement, shortly followed by February's release post to find out what's coming up this month on poisonappleprints!
See you in the next post,
Harley
