Cheshire Cat (Clean Variant)
Added 2023-07-15 02:04:17 +0000 UTCSorry for the slight delay on this one, the patterns turned out to be a little tricky but he's now all finished and ready to download below. The test print ran smoothly and he stands without an issue, I've printed him at 13.5cm which makes him slightly taller than the mickey model. He also has no thin or fine areas so he should print fine on either resin or FDM printers.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
RAFT SHAPE SKATE
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
SUPPORT NORMAL / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
If you have any questions or issues let me know. I'll be working on the patterning for the Ornamental version throughout tomorrow, so he'll be up on the page over the next couple of days.
See you in the next post,
Harley
