Mrs. Potts (Clean Version)
Added 2023-08-05 23:09:15 +0000 UTCSorry for the delay, my little one loves bringing me home bugs! but Mrs. Potts is now available to download below. The test print ran perfectly with a drain hole placed at the bottom to prevent suction issues, I printed her at 13.5 cm tall which makes her about twice the size of Chip. She also has no thin or fine areas so there shouldn't be any issues printing on either resin or FDM.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
RAFT SHAPE SKATE
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
SUPPORT NORMAL / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
If you have any questions or issues let me know! This is a huge space to pattern so the ornamental version should hopefully be out later tomorrow.
See you in the next post,
Harley
