Remy (Clean Variant)
Added 2023-08-17 03:23:00 +0000 UTCThe first version of Remy is now available below. I've included a solid version and a hollowed version to prevent resin pockets in the spoon. I printed him at about 10cm which makes him a little smaller than our Mickey model, he also has no thin or fine areas so he should print fine on either Resin or FDM.
RESIN
45 DEGREE ANGLE
DENSITY 75 PERCENT
RAFT SHAPE SKATE
FDM
LAYER HEIGHT 0.2
INFILL AT 20 PERCENT
TREE SUPPORTS
GYROID PATTERN
220 NOZZEL TEMP
60 BED TEMP
65 MM/S
SUPPORT NORMAL / TOUCHING BUILD PLATE
OVERHANG 45
SUPPORT PATTERN LINES
Any questions or issues let me know! I'll be working on the Ornamental version throughout tomorrow so hopefully if all goes well he should be out on the page sometime Friday!
See you in the next post,
Harley
