Vise Stop - Models & Drawings
Added 2020-08-15 17:22:40 +0000 UTCHey Patrons! Attached here are the models and drawings for the vise stop I made in this week's video. These have also been added to the shared Patron drive where all the models and drawings live:
https://1drv.ms/f/s!AjEukTfa9GrpauR9ENcKu5q7Bhk
As always, remember that the link to the Patron drive changes every month, so don't bother bookmarking it. I put a new link here each month.
Comments
I did... I need to watch it again! Thanks Quinn š
Jon Lloyd
2020-08-20 15:18:11 +0000 UTCFor metric, I don't think O/U reamers are a thing. Instead, you buy them by tooling class for the fit you want. So, to get an RC2 (or H7 in metric) fit on a 6mm hole, you buy an H7 6mm reamer. I covered this a bit in my Fits & Tolerances video, if you happened to catch that.
Blondihacks
2020-08-20 15:17:13 +0000 UTCEnjoyed this video! Iām trying to find under/over reamers. Iām in Oz so Iām all metric but I have 6, 8 & 10mm only. Found an imperial set on eBay but only $79 US...
Jon Lloyd
2020-08-20 14:49:30 +0000 UTCThank you, Quinn...Nice chips, as always.
Bruce Rose
2020-08-19 23:10:12 +0000 UTCThanks Dean! :-)
Blondihacks
2020-08-16 21:06:22 +0000 UTCVery nicely done, Blondi-Quinn. Just a comment on the way this casting was made, when you make a crankshaft out of solid stock, this it the same way you do it. It's so when you turn the long crank diameters between centers you do not warp the crank "throw" part, leaving you with a crooked crank. You are doing very well from my 30+ year reign :) of experience. See you on Youtube! Have a great weekend, and God Bless. Dean
Dean Williams
2020-08-15 17:49:18 +0000 UTC
