News. About July release (Jungle Warriors)
Added 2022-06-30 23:01:50 +0000 UTCI throw out 5 free models to the general access. Please give feedback PM
https://drive.google.com/drive/folders/1Byvw9x63Kkb660FjYuLGTXBAdV7gyi3R?usp=sharing
Comments
The stand is separately in the folder. Well, if you send me a PM, I'll send it
2022-07-07 08:47:01 +0000 UTCWhat I downloaded bases was on the stl file only the sniper did not have base but all others had figure weapon and base all on the same stl
Harold
2022-07-07 00:30:12 +0000 UTCBases are already separated from models everywhere.
2022-07-06 20:54:16 +0000 UTCWill you be sending out another set of stl files where the figure, weapon and the base are separated I use other bases and dont want to waste resin on bases I will not use
Harold
2022-07-06 11:03:37 +0000 UTCloving these
David Sives-Rutherford
2022-07-06 10:33:14 +0000 UTCRe-downloaded and re-printed new files and file 2 sword failed but could be my setting I use really fast settings. This is one of the reasons I always use my own supports. Model 1 looks good now and printed fine.
Tharehl101
2022-07-05 02:20:44 +0000 UTCHow to get tell what happened?
2022-07-04 18:57:46 +0000 UTCSorry man I have 2 printers a mars 2 pro and a Saturn. I always have problems with pre supported models. This is why I always do my own supports. But, there wasn't any that wasn't supported to test with. I tried the 2nd model on both printers and failed on both. I'll re-download the new files and try them again later tonight. Not at home right now sorry man.
Tharehl101
2022-07-03 21:45:00 +0000 UTCModels updated. Everything is fixed
2022-07-03 21:21:36 +0000 UTCUntil there is a new release, the old release will remain in effect.
2022-07-03 21:00:31 +0000 UTCHi, new Patron here. Is there any way to receive/purchase rewards from previous months? If so how does that work? Thanks.
Aevox23
2022-07-03 18:36:53 +0000 UTCAre these test models. I check everything before release. What printer did you print to?
2022-07-03 16:08:09 +0000 UTCModel one doesn't have a belt on its front side. Model 2 failed to print 2 times. Printed the others fine. All seem a bit undersized to me, used 28mm scale ragdoll to test next to.
Tharehl101
2022-07-03 00:27:38 +0000 UTC
