Supported Skeletons now Available!
Added 2020-12-02 20:31:11 +0000 UTCThe supported and test printed skeletons have been uploaded to the December sync folder, and are ready for your printing pleasure.
A word of warning though, the spears and bows/arrows in particular are quite thin, and require a bit of care when removing supports. The use of hot water to aid support removal (Highly recommended) also is a bit of a two-edged blade with this, as the thin weapons are prone to easily bending/warping. You may need to manually straighten them a bit after support removal. (I found myself using water to aid support removal, and then dipping the spears/bows back into the hot water to then straighten them.)
Comments
Cheers - they're a bit on the flimsy side!
Wyrm Forge
2021-02-04 22:56:51 +0000 UTCOMG printed these skelletons and they are so freakin detailed. And the supported ones printed without a flaw. even this tiny spears and there tiny bony arms come out perfect. Only the standing skelleton with bow has little too much support on his left arm.
2021-02-04 21:47:33 +0000 UTCmine downloaded ok. will post a print when i get some more resin. lol
2020-12-06 07:33:00 +0000 UTCSync sucks half the time. :(
Steve Moss
2020-12-03 09:20:21 +0000 UTCI printed all yesterday (with autosupports) and only one spear that was detacched from the bottom and I think one feet of a skelly that went also "compressed" but printed quite Good... so ..Good job.. and today Sync again it's takin foreve (24h to donwload it says) :P
Antonio Miguel Martorell Ferriol
2020-12-03 07:43:22 +0000 UTCYeah, I think it was simply wrong timing on my side and heavy load on the servers end. Today at 5:30am (German local time) the download went as expected fast.
Tim Albers
2020-12-03 05:56:24 +0000 UTCSame problem here. Assuming sync's being pounded on, and will try again later. DDOSes are a thing, sadly.
2020-12-02 21:27:31 +0000 UTCYikes - maybe something with your connection to sync's servers at the moment? Or is this all the time? It took around 5-10 minutes to download the zip here.
Wyrm Forge
2020-12-02 21:24:40 +0000 UTCI don't know why it is but downloading the files takes ages.... this is predicted to take 3 hours total... that is insane for 500MB... :S
Tim Albers
2020-12-02 21:06:35 +0000 UTC
