3D Printing my own $2,500 Airless Basketball... sorta
Added 2024-03-08 14:32:25 +0000 UTCThis video was way too much fun. Also, note to self, when you buy a new wireless mic make sure to test it for more than 5 minutes before jumping into a video recording. I didnt realize it was so bad. Will be futzing with that later today after I clean up all of the broken basketball bits
I'd definitely recommend printing one of these in a Flexible PLA or that Super PLA from overture. So much fun
Comments
Try some Shore 60D filament, it is a lot firmer than the Shore A stuff.
G. Michael Bridge
2024-03-08 18:54:56 +0000 UTCWondering if PA or PA-CF would increase Bounce and durability?
Randy Allman
2024-03-08 16:21:29 +0000 UTCnice work as always, any time frame on sharing the n4m max profiles you talked about in your last few posts like .32 or the petg???
Paul Burtsell
2024-03-08 16:04:49 +0000 UTCThe only thing holding me back from printing one was waiting for you to make a video about it. I think I'll need some more filament. Thanks for the rundown!
Marshall Woodworks
2024-03-08 15:34:00 +0000 UTCI have to get started on mine
Javier Bermudez
2024-03-08 15:15:58 +0000 UTC
