They said it couldn’t be done 🤣😂🥶
Added 2022-01-22 22:16:28 +0000 UTCResin 3D Printing outside in the snow 26f out 🤣😂🤘
Should have a video up tomorrow on this dumbass project I had to try
Comments
lol I did not notice the heater at first
jillatized
2022-01-25 23:07:27 +0000 UTCvery interesting. after reading the other comments i dont think the camera would be an issue since i am a scuba diver and taking a good camera down in very cold water in a case isn't effected by extreme cold. but like Jonah asked: how long the resin sat in the cold before use AND how long after pouring did it stay out in the cold before and during the print. Also: as ive only used a couple manufacturers of resin, would/could some resins be more susceptible to cold than others?
Carlo Krun
2022-01-22 23:19:11 +0000 UTCYeah I might be cheating 😂
Uncle Jessy
2022-01-22 22:57:02 +0000 UTCI did capture the temp of the resin before printing outside
Uncle Jessy
2022-01-22 22:56:50 +0000 UTCHaha you and me both, it’s inside
Uncle Jessy
2022-01-22 22:56:01 +0000 UTCAnd to think I have issues at the 60° my basement gets this time of year
The3DHobbyist
2022-01-22 22:21:25 +0000 UTCInteresting project. Couple of questions I hope you can answer on your video tomorrow. How long was the resin exposed to the cold prior to pouring into the vat and before you started the printing?
Jona Smith
2022-01-22 22:20:36 +0000 UTCI am more worried about your camera then the printer.
Mark Morgan
2022-01-22 22:17:17 +0000 UTC
