Testing out CHEPs profiles & bed leveler
Added 2022-03-27 16:48:52 +0000 UTCThis honestly was pretty wild! I hate Cura with a passion but might have to make the switch.
Going to play around with his profile more and see if I can dial it in a bit more for my needs with printing jobs for Etsy and will share back here. So far it was a good bit faster than my simplify3D profile!
Comments
I came for the elegoo neptune 2 profile. Am I just not seeing it?
Jeremiah Verba
2022-05-06 14:16:38 +0000 UTCGetting my Neptune 2S tomorrow so will try a CHEP cube using the new CHEP profile. I couldn't see yours?
GameOrNought
2022-04-26 21:57:56 +0000 UTCAre the print settings you used on the Neptune 2s (CHEPS etc.) in the facebook group or do you have a link for them here somewhere.
Juliusz Wilczynski
2022-03-29 01:56:30 +0000 UTCI was an early adopter of S3D as a slicer (been using it since 2015), but they really haven't kept up with the rest of the slicers, their last release (4.1) was back in December of 2018, and there's a lot of new features & functions in the competing slicers at this point. Learning & migrating to a new slicer does take some time, but it is worth it.
G. Michael Bridge
2022-03-28 02:51:38 +0000 UTCWhat slicer fo you like? I have started using Super Slicer and it is way better so far but running into some minor things I need to figure out. I tried cura on my ender 5 plus and it was bad. I get my resin in june so will want to start looking at slicer for that soon.
Justin Posey
2022-03-27 16:50:50 +0000 UTC
