Smaller cut dome now available!
Added 2017-04-28 17:32:01 +0000 UTCI've finished the smaller cut dome for smaller print beds if the 200 cut is a little too large. Full CSR spec, all panels available. I'm publishing the lower ring very soon but this will get you started :-) As always, should print fine at .3 layer with 10 - 20 percent infill. This is currently published in the Patreon early bird share. Enjoy printing :-)
Comments
Yup 4mm, I used 15mm I think. The walls are 3mm, so 6mm for two, 10mm is tight but may work, 20 also but a bit longer.
Michael Baddeley
2017-05-01 17:29:27 +0000 UTC
