Possibly my worst abuse of 3D printing yet.
https://www.youtube.com/watch?v=YIwK45z3Mxk
The description of the video has an openscad file for making your very own 3D printed flame whoosher. Not that I actually recommend it, as whooshers are very dangerous.
It would be good to know if there's much standardisation between budget-store toilet air fresheners. The base on this one is about 25mm or 1" wide, and that's what the whoosher is based on.
Andrew Donaldson
2020-06-21 08:21:54 +0000 UTCAndrew Donaldson
2020-06-21 07:31:40 +0000 UTCMichael Thompson
2020-06-20 10:08:12 +0000 UTCMike Page
2020-06-20 02:38:26 +0000 UTCBig Clive
2020-06-20 02:14:00 +0000 UTCMike Page
2020-06-20 01:39:01 +0000 UTCBig Clive
2020-06-20 00:35:04 +0000 UTCPhoton Phil
2020-06-19 23:31:22 +0000 UTCBig Clive
2020-06-19 22:54:36 +0000 UTCMike Page
2020-06-19 22:52:23 +0000 UTCBig Clive
2020-06-18 22:06:05 +0000 UTCAndrew Donaldson
2020-06-18 21:18:12 +0000 UTCBig Clive
2020-06-18 20:54:31 +0000 UTCPaul Hill
2020-06-18 16:37:09 +0000 UTCJohn Carr
2020-06-18 12:32:44 +0000 UTCMichael Thompson
2020-06-18 08:27:37 +0000 UTCBig Clive
2020-06-18 03:31:05 +0000 UTCJohn Carr
2020-06-18 01:02:19 +0000 UTCJohn Carr
2020-06-18 00:55:39 +0000 UTCElliott Krimchansky
2020-06-17 23:02:37 +0000 UTCEarl Plotner
2020-06-17 23:02:28 +0000 UTCMichael Thompson
2020-06-17 22:58:06 +0000 UTC