Kekreations 3D

BONUS FREE Jump Ring Helper Ring

Added 2025-04-18 00:01:13 +0000 UTC

Hey everyone!

I'm apparently on a functional ring kick this week, and have been meaning to make this little device for ages now! The jump ring helper helps open and close jump rings for keychains and jewelry. My hands always end up hurting after a bit if I have to use two pairs of pliers to open and close a lot of jump rings, so this little ring helps make it so much easier!

Since this is a small little design it's just a bonus and not counted towards your monthly rewards, like most of my accessible designs. This can be helpful for anyone with hand or joint problems or those just tired of opening and closing a bunch of these little rings! As always, your commercial license covers this design if you want to sell prints.

Print recs:
2-3 walls
5-15% infill
No supports
Add brim if needed
Scale up or down as needed for different fingers

Up on Cults3D https://cults3d.com/en/3d-model/jewelry/jump-ring-helper-ring

Makerworld: https://makerworld.com/en/models/1328729-jump-ring-helper-ring#profileId-1366581

MMF: https://www.myminifactory.com/object/3d-print-jump-ring-helper-ring-512261

and Thangs: https://thangs.com/designer/Kekreations/3d-model/jump%20ring%20helper%20ring-1311681

Hope it's helpful to y'all!

Thanks so much for all the support,