Behind Door #3
Added 2021-12-03 01:16:59 +0000 UTCCrypt Skeleton 004
Picked out by my other half. i'll tell her you said thanks
Comments
First, prime the model black. you might consider adding a touch of glossy black to the mix. Then get a brown color similar to #65574e or #756556 start your search here: https://www.dakkadakka.com/wiki/en/Paint_Range_Compatibility_Chart I'd dry brush it on over and over with thin coats so I could target the build up and leave the black areas as black as possible. Then you need a wash, a earthy/dirt around all the "black" areas and the brown near it. Then a sepia over the "light" areas. If you want to go all out, you'd mix in some grey into your brown and do some highlights on the most raised rivets, bolts, skull tops, etc. That should get you close. may take a few tries, but that's the joy of printing - you can always try again.
Mortcog
2021-12-04 01:03:25 +0000 UTCQuote from a member of my discord who can't actually comment The color is actually brown instead of bronze lol pine cone apparently Brown and grey XD #65574e; #a3958c; #11100d; #31424c; These colors are the dominant ones and some from the edge of the ranges. To paint like the renders you basically would want a slightly shiny woodish color with some dark washing and perfect lighting always on them lol
2021-12-04 00:30:16 +0000 UTCSorry didn't notice my message made no sense
Ray Dwigans
2021-12-03 22:20:08 +0000 UTCSorry i dont understand
2021-12-03 21:19:20 +0000 UTCHow would I paint my models to look like your aged bronze look
Ray Dwigans
2021-12-03 19:04:33 +0000 UTC
