customminiaturemaker

Cracked Earth and Decaying Stone Tile Base Sets

Added 2023-12-15 23:57:30 +0000 UTC

Hey Miniature Makers!

It's the 15th of the month and that means it's time for a load more bases!

This month we are bringing back another favorite design from the rollers in base form, 'Cracked Earth'. This base design works well for pretty much every army or monster as it is so versatile.

Along with this, we have also made a 'Decaying Stone TIle' base set as well. This will work perfectly for temples, dungeons, and ruined buildings!

New Scatter Packs:

In the scatter welcome pack, there are lots of items that go perfectly with the Cracked Earth, from rocks to skulls to ammunition but there was less that would go well with the tiles.

Therefore, we have made a set of pottery urns with cracked and uncracked versions and piles of coins for you guys. These should work great for decorating the Decaying Stone Tile bases to bring them to life as a dank dungeon. Remember, you can also use these scatter models to decorate your terrain and dungeon tiles as well!

Cracked Earth and Ancient Tile Base Sizes Included:

25mm (5 versions), 28mm (3 versions), 32mm (5 versions), 40mm (3 versions), 50mm (2 versions), 65mm (2 versions), 90mm (2 versions), 100mm (2 versions), 65x35mm (3 versions), 75x42mm (2 versions), 90x52mm, 105x70mm, 120x92mm, 170x105mm

New Scatter:

Coin Set: Single Coin, Two Coins, Three Coins, Coin Pile 1, Coin Pile 2

Urn Set: Urn 1, Urn 2, Urn 3, Urn 4, Urn 5, Bowl (each also with a cracked version)

Ready for Printing:

The bases will be laid flat for FDM printing and fully pre-supported for resin printing.

We have developed a special curved lip on the bottom of the bases that reduces the pressure when printing in resin on the bottom lip, meaning you get nice perfect edges. This lip also means that when you print in FDM it does not spread out at the edge and the bases stay the exact size they should be.

The lip also allows for the bases to be printed flat on the build plate with resin printers while allowing a tiny gap around the edges so they can be removed without a flex plate. We suggest this is done only by more experienced users of resin printers. This works best with smaller bases up to 65mm and if you do choose to do this, make sure to have 4 bottom layers set and have a layer height of 0.05mm.

How to Download

Now added to your MMF library for December

Keep on Rollin'

Simon and Justin